Attach to the drawer first Cut the notch for the slide at least 1/8″ wider on each side, to the depth of the drawer bottom. With one screw holding the front of the slide in place, measure from the drawer side to make sure the slide sits centered and parallel. Mount the slide 1/32″ back from the front of the face frame. Click to see full answer. Just so, what are the different types of drawer slides? How to Install 5 Types of Drawer Slides Ball Bearing Drawer Slides. Soft Close Ball Bearing Drawer Slides. Bottom Mount Drawer Slides. Side Mount Drawer Slides. Center Mount Drawer Slides. Also, how do I choose a drawer slide? For side-mount and center-mount slides, typically measure the distance from the front edge of the cabinet to the inside face of the cabinet back and then subtract 1″. For under-mount slides, measure the drawer length. Slides must be the same length as drawer to work properly. Subsequently, question is, how do I make my metal drawers slide smoothly? Lubricating metal and ball-bearing drawer slides Remove the drawer. To do so, carefully pull it straight out to slide it off of the runners. Use a damp cloth to clean the area you’re preparing to lubricate. Apply the lubricant on the runners. Clean up any excess lubricant. Put the drawer back on the runners. How do you remove self closing glides drawers? How to Remove Drawers With Self-Closing Glides Open the drawer and pull out as far as possible. Look on the side of the drawer glides for retention screws or clips. Make sure the drawer is extended to the fully open position. While lifting the front of the drawer, pull it forward. Once the back of the drawer has cleared the cabinet, lift it off the tracks.