Add 30 mL of distilled water to your buffer and stir well. Measure and record the pH (as pH after dilution with water). Divide your buffer solution into two portions in separate 50 – 100 mL beakers. Add 1-2 mL 0.10M HCl to one of the portions, and 3 mL 0.10M NaOH to the other.Click to see full answer. In this manner, how do you make a buffer solution in a lab? Methods to Prepare Buffer Solutions Add water to make up to 1 L. Add water to make up to 1 L. (Alternatively, dilute 100 mM phosphoric acid (sodium) buffer solution (pH=2.1) ten times.) Add water to make up to 1 L.Similarly, is water a buffer? Water is a buffer albeit a poor one. This is because H20 seelf ionises to form H30+ and OH-. To form an acidic buffer buffer you need a weak acid with the conjugate base. As there will be hydronium and hydroxide ions present yes it acts as a buffer but is a horrible one. Also question is, how do you test a buffer solution? Testing the Buffer (1/10 strength) – (a) Measure 5.00 mL of buffer prepared in the previous step into a beaker and add 45 mL of distilled water into the beaker – mix. Pipet 10 mL of the resulting diluted buffer into a large test tube. Measure the pH. Add 0.10 mL of 0.10 M HCl and measure the pH again.What are the types of buffer solution? Types of Buffer Solutions Buffers are broadly divided into two types – acidic and alkaline buffer solutions. Acidic buffers are solutions that have a pH below 7 and contain a weak acid and one of its salts. For example, a mixture of acetic acid and sodium acetate acts as a buffer solution with a pH of about 4.75.