The fabric softener will not siphon out of the dispenser properly if it is too thick. If the fabric softener will still not dispense after being diluted and verifying proper flow through the dispenser drawer, you could have a component failure in the dispenser assembly or a control problem.Click to see full answer. Regarding this, why does my fabric softener not dispense?* Clean the washer detergent drawer periodically with a soft cloth to avoid detergent buildup. Check the inlet hose screens for a blockage. If washer is not getting enough water pressure, the fabric softener will not drain. * Use a pair of needle nose pliers or a suitable tool to remove the filters.Also Know, why is my fabric softener drawer full of water? This tube often gets blocked by the fabric softener itself. If you remove the dispenser drawer and take off the cap or device you can give the whole thing a good clean out. To test the function, hold the soap drawer under a tap and allow water to fill the fabric compartment to overflowing. Secondly, how do you unclog a fabric softener dispenser? Add enough warm water to cover the dispenser. Mix in a tablespoon or two of liquid laundry soap, swirling it into the water with your hand. Allow the dispenser to soak for 10 minutes or so, touching the fabric softener buildup to see if it has loosened. If not, soak the dispenser for another 20 minutes.Where does fabric softener go in GE washer?Open the sealed dispenser’s tab, and pour the softener into the dispenser. After the softener has drained into the dispenser, push the dispenser tab down Continue with adding your detergent and your load. After closing the lid, select your settings. Select a fabric softener option on the control panel of your washer.
