Passive-interface command is used in all routing protocols to disable sending updates out from a specific interface. This behavior stops both outgoing and incoming routing updates. In OSPF the passive-interface has a similar behavior to EIGRP. The command suppresses hello packets and hence neighbor relationships.Click to see full answer. Moreover, what is IP OSPF passive interface?If an interface is configured as a passive interface, it does not participate in OSPF and does not establish adjacencies or send routing updates. However, the interface is announced as part of the routing network. This command requires the LAN Base Services license.Furthermore, how do you set all LAN interfaces as passive? You can set all interfaces as passive by default by using the passive-interface default command and then configure individual interfaces where adjacencies are desired using the no passive-interface command. Subsequently, question is, what is a passive interface? The passive interface Command With EIGRP running on a network, the passive-interface command stops both outgoing and incoming routing updates, since the effect of the command causes the router to stop sending and receiving hello packets over an interface. This is the output of the show ip eigrp neighbors .How do I turn off passive interface? Disable the RIP Passive Interface On switch 1, enter the configuration mode for the router. SEFOS# configure terminal SEFOS(config)# router rip SEFOS(config-router)# network 10.0.0.1. Disable the passive interface status for VLAN 1. Review the RIP interface for the periodic updates sent over the interface.
